helop.blogg.se

1. #10g mac ethernet project install
2. #10g mac ethernet project driver
3. #10g mac ethernet project software
4. #10g mac ethernet project code

Tgec_mdio_info.name = DEFAULT_FM_TGEC_MDIO_NAME įm_memac_mdio_init(bis, &tgec_mdio_info) (struct memac_mdio_controller *)CONFIG_SYS_FM1_TGEC_MDIO_ADDR (struct memac_mdio_controller *)CONFIG_SYS_FM1_DTSEC_MDIO_ADDR ĭtsec_mdio_info.name = DEFAULT_FM_MDIO_NAME Srds_s1 >= FSL_CHASSIS2_RCWSR4_SRDS1_PRTCL_SHIFT Struct ccsr_gur *gur = (void *)(CONFIG_SYS_FSL_GUTS_ADDR) However, I am still having problems getting a connection. I loaded the fman microcode and I no longer get the firmware error. I wanted a LS1046ARDB as a test platform, but none have been available for purchase during our development phase. Unfortunately, I only have my new board as a test platform.

#10g mac ethernet project driver

Given that the SFP+ Cage is a generic removeable module, I do not have any idea what driver the eth.c should be attempting to call. Should that be something different, or the problem before it even gets there? Is there environment variables that I need to set before it will load the Ethernet? For example. Is that true? Or do I need to program separate files for drivers? I am assuming that any driver needed is bundled into the binary. Into the QSPI, I am only programming the bl2_qspi.pbl and the fip_uboot.bin. I get a printout ofįman1: Data at 00000000f7a50bf0 is not a firmwareĪfter this printout, the message is "No ethernet found. Finally, I also built the U-Boot for the LS1046ARDB and used that instead of my boards fip_uboot.bin.

#10g mac ethernet project code

I also tried basing the code on the LS1043ARB since other posts recommended it. This 10G Ethernet is the only port on the board. Due to parts availability, the 10G Ethernet was done with an SFP+ Cage because all other parts were extremely long lead time.

#10g mac ethernet project software

Prepare the design template in the Quartus Prime software command-lineĪt the command-line, type the following command: The regression ensures the design template passes analysis/synthesis/fitting/assembly steps in the Quartus design flow. Note: When a design is stored in the Design Store as a design template, it has been previously regression tested against the stated version of Quartus software. par file you downloaded, click next, followed by Finish, and your design template will be installed and displayed in the Project Navigator pane in Quartus.

#10g mac ethernet project install

If you don't see your design template in the list, click on the link that states install the Design Templates circled below:īrowse to the. You will see a list of Design Templates projects that you have loaded prior as well as various "Baseline Pinout Designs" that contain the pinout and settings for a variety of development kits. After entering the project name and folder on the first panel, the second panel will ask you to specify an empty project or project template.

The second means to bring up the project template is through the New Project Wizard (File -> New Project Wizard).

par file and Quartus will launch that project. In releases 16.0 or newer, you can simply double click on the. The combination of this information is what constitutes a. qar file) and metadata describing the project. par file which contains a compressed version of your design files (similar to a. The file you downloaded is of the form of a. Note: After downloading the design example, you must prepare the design template. Prepare the design template in the Quartus Prime software GUI (version 14.1 and later)